Recent Jobs For Wagmore Garage Doors

March 9, 2026 | Saint Augustine, FL

Failed Torque Master spring causing binding through radius. 16x7, Genie 2028 Chain Drive, installed 2018. Conversion to torsion springs completed: removed TM assembly, installed bearing plates, center bearing, cables, springs, drums & shaft. Reset opener limits, tested operation. Door operating smoothly. 1-yr maintenance approved.

March 6, 2026 | Saint Augustine, FL

Completed Safe & Sound Inspection on 16x8 Wayne Dalton with Torque Master spring system and Genie 2028 opener. Elizabeth reported broken springs — confirmed on inspection. Also noted dry hinges and loose chain. Completed a torsion spring conversion and lubricated hinges, springs, rollers, bearings, and drums; adjusted chain tension. Door and opener ...

March 5, 2026 | Saint Augustine, FL

Performed Safe & Sound Inspection on a 16x7 Wayne Dalton door with a Genie 2028 opener. Customer reported a suspected broken TorqueMaster spring and loose chain. Inspection revealed the TorqueMaster spring to be intact but improperly adjusted, preventing the opener from functioning correctly. Chain was confirmed loose, and a loose bolt ...

March 4, 2026 | Saint Augustine, FL

Completed Safe & Sound Inspection on a 16x7 insulated Wayne Dalton door with mismatched torsion springs. Customer's sensor had fallen off track and was taped—door wouldn't operate. Reinstalled and aligned sensors; door restored to full operation. Lubricated hinges, springs, and rollers; tightened opener chain; greased rail. Paid by check. ...

March 3, 2026 | Saint Augustine, FL

A Nocatee homeowner called about a broken spring, but our Safe & Sound Inspection uncovered corroded cables, bottom fixtures, and a faulty sensor connection on both of her Clopay doors. Wagmore replaced the spring, cables, and bottom fixtures on both doors, corrected the sensor wiring, and performed full lubrication maintenance — ...

March 2, 2026 | Nocatee, FL

Completed a Safe & Sound Inspection on a 16x7 Wayne Dalton door after the customer reported unusual noise. Inspection revealed the door needed a hinge adjustment, which we completed. Customer also enrolled in our maintenance plan to keep the door safe and running smoothly for years to come.

February 27, 2026 | Palm Coast, FL

Safe & Sound Inspection on two doors. Performed a Safe & Sound Inspection on a 16x7 uninsulated door with a LiftMaster belt drive opener. Customer reported broken springs and cables. Inspection confirmed both springs were broken; cables had slipped off the drums but remained intact. Rollers showing wear, hinges dry.&...

February 26, 2026 | Jacksonville, FL

Mr. Zreik stated his garage dr was noisey and would not open all the time. Installed LiftMaster 6690L opener with 7-ft rail; programmed 2 remotes, and 1 keypad. Full door rebuild: replaced springs, cables, rollers, bearings, bearing plates & shaft. Replaced failed bottom seal & retainer; set opener limits.

February 25, 2026 | Jacksonville, FL

Completed Safe & Sound Inspection on a 16x7 Wayne Dalton Torque Master door with Genie 2028 Chain Drive opener. Customer reported no current issues; a previous concern had been resolved with reprogramming. Door and opener are in mostly good condition. Inspection revealed the Torque Master spring is oversized and not balancing ...

February 24, 2026 | Saint Augustine, FL

Safe & Sound Inspection on two doors. 16x7 LiftMaster belt drive: found grinding rollers, loose belt, and previously damaged operator bracket. 16x8 LiftMaster chain drive: found off-center opener, unlevel back-hang brackets, and failed roller. Replaced rollers and operator brackets on both doors, correctly reinstalled 16x8 opener and brackets, lubricated all ...

February 23, 2026 | Palm Coast, FL

A Nocatee customer called Wagmore believing both springs and cables were broken on their 16x7 overhead door. After a thorough Safe & Sound Inspection confirmed broken torsion springs and cables off the drums — but still intact — we replaced both springs, lubricated the door, and restored safe operation, backed by our ...

February 20, 2026 | Jacksonville, FL

Upgraded both garage doors with new LiftMaster 2220L chain drive openers, torsion springs, cables, rollers, drums, bearing plates & bottom seals. Removed old extension springs & Craftsman openers.

February 19, 2026 | Nocatee, FL

Customer contacted us after both springs and a cable broke, leaving his garage door inoperable. We replaced the broken springs and cable, restoring full function to the door. He also enrolled in our maintenance plan to keep both of his garage doors operating safely and reliably for years to come.

February 18, 2026 | Flagler Beach, FL

Customer contacted us after their door came off the track and began making noise. We performed a full door system reset and rebalance to restore safe, smooth operation.

February 17, 2026 | Jacksonville, FL

Performed Safe & Sound Inspection on a 16x7 Wayne Dalton door with Linear opener. Customer reported no maintenance in six years and raised concerns about exposed sensor wires. Inspection confirmed exposed and loose wiring on both safety sensors, a burnt-out lightbulb, missing pull cord handle, dry hinges causing black dust ...