Recent Jobs For Wagmore Garage Doors

April 20, 2026 | East Palatka, FL

When this East Palatka homeowner's Amarr door came off track, our $0 Safe & Sound Inspection revealed tangled cables, displaced rollers, a folded bottom panel, and a bent LiftMaster trolley — damage that's easy to miss without a trained eye. The full reset and trolley replacement are underway, and this door will ...

April 17, 2026 | Saint Augustine, FL

Performed a torsion spring conversion on a 9 x 7 wood door with a genie screw drive opener. During my inspection, I confirmed that one of the extension springs were broken. I removed the old extension spring system, and installed a new bearings, plates, drums, cables, shaft, and springs. The torn spring ...

April 16, 2026 | Jacksonville, FL

John in Jacksonville reports his two-car garage door system is operating inconsistently — the door and opener fail to complete cycles reliably. Observed issues include the door initiating descent then stopping mid-travel, as well as failing to remain in the closed position after closing. Customer is requesting a full inspection, diagnosis, ...

April 15, 2026 | Saint Augustine, FL

Clifton's garage door had stopped responding to the remote entirely — no electronic open, no electronic close, manual operation only. Our tech reprogrammed the remote to the opener during a $0 Safe & Sound Inspection, and the door was back to full automatic operation before he left. That's Wagmore.

April 14, 2026 | Middleburg, FL

Technician replaced all hinges and installed 12 ultra-quiet rollers on a double-car 8-foot door, lubricating all hardware upon installation. Full maintenance was performed on both doors and openers, including spring tension adjustment, opener limit reset, and Genie motor chain tightening. Upon completion, the door was cycled multiple times — customer observed and ...

April 13, 2026 | Jacksonville, FL

Upon arrival, the customer reported concerns about door safety and that the door wouldn't open fully, preventing him from parking inside. Inspection revealed several issues including improperly set opener limits, a sagging chain, worn sprocket gears, fraying cables, aged 2012 springs causing a heavy door, and lack of lubrication throughout. Customer ...

April 10, 2026 | Saint Augustine, FL

Technician inspected a 16x7 Wayne Dalton door and confirmed a broken opener chain and a failed Torque Master spring, with the spring failure identified as the likely cause of the chain break. Multiple failed components — including an opener that would only run in the down direction — made replacement the only ...

April 9, 2026 | Saint Augustine, FL

This Saint Augustine garage door needed a complete refresh — worn bottom seal, failing springs, and frayed cables were all working against it. Our $0 Safe & Sound Inspection identified every issue and we knocked it all out in one visit with a double spring replacement, new cables, and a fresh bottom ...

April 8, 2026 | Jacksonville, FL

Cstomer stated that garage door was not working. Performed $0 Diagnostic Inspection on a 16x7 Overhead Door with OHD opener. Found one broken spring and a broken operator bracket. Completed an double spring replacement and adjustable operator bracket.

April 7, 2026 | SAINT AUGUSTINE, FL

Single Spring Replacement -9x8 Vinyl Back Insulated Door - LiftMaster Belt Drive Opener. Broken torsion spring found on inspection. Installed new spring and center bearing. Corrected opener limits, swapped sensors to prevent sun interference, re-spliced wiring. Lubricated all moving parts. Door and opener operating correctly. Customer satisfied. 

April 6, 2026 | Saint Augustine, FL

Returning customer Kevin, requested opener replacement due to noise post-rebuild. Opener damage from broken spring operation noted/declined at prior visit. Installed LiftMaster 2220-L w/ sensors, wall button, remote, existing wiring. Programmed limits, lubed rail, vehicle, MyQ app.

April 3, 2026 | SAINT AUGUSTINE, FL

Safe & Sound Inspection on two 8x8 uninsulated Clopay doors with Genie 2028 openers. Customer reported one door not opening and both doors noisy. Found corroded sensor terminals on door 2 and dry hinges with metal shavings on both doors. Completed two maintenances and sensor replacement. Replaced both sensors on door 2, lubed ...

April 2, 2026 | Saint Johns, FL

Customer attempted DIY bottom seal replacement but couldn't find compatible rubber for the older door. Confirmed our retainer would fit, presented estimate, customer approved. Removed old retainer and installed new aluminum retainer and T-channel track. Lubricated track and installed new seal rubber. Reset opener travel limits and confirmed no light ...

April 1, 2026 | SAINT AUGUSTINE, FL

Arrived to customer reporting a shaky opener. Discovered a broken torsion spring. Completed Safe & Sound Inspection and presented multiple repair options. Customer completed a full door rebuild. Weighed door and installed correct spring line — new shaft, bearings, springs, cables, drums, and center bearing plate. Set proper spring tension, tested ...

March 31, 2026 | Jacksonville, FL

Installed two new 8x7 non-insulated doors. Removed both existing doors and installed all new hardware — tracks, springs, and panels. Adjusted springs to proper tension and confirmed both doors operating correctly. Installed outdoor side trim on both doors; customer was very happy.